We built these wholesale PET blowing IR lamps to fix a real headache on the production floor: getting steady, reliable heat into your Sidel machines—whether you’re running the older SBO lines or the latest Matrix models—without messing with wiring or tweaking the reflector housing. The whole point? Plug it in, and it just works. No trade-offs. No downtime. Here’s the heart of it: power, voltage, and fit. We lean on high-density shortwave heat, usually hitting 2500W at 400V. That kind of punch gets the temperature up fast, so warm-up time shrinks and your cycles stay tight. The tube length is matched to the reflector space across Sidel machines, so you get the same heat profile without hunting for new mounting points. That 400V setup also keeps line-side current lower, which eases stress on your electrical bits. But it packs a lot of heat into a small footprint. So your cooling system needs to be up to the task. If airflow in the cabinet is borderline, thermal management will be the bottleneck before the lamp ever is. Now, what’s inside. The tube is quartz, because it responds instantly and handles the shock of rapid on/off cycles without blinking. A reflective coating on the outside pushes more IR energy forward, so more heat actually gets into the PET preform. The halogen fill keeps filament temperature steady, which means repeatable heating—cycle after cycle, thousands of times over. For the electrical connection, we use R7s connectors. That gives you a direct, solid fit that lines up with Sidel’s original spec. No custom brackets. No extra wiring harnesses. No alignment headaches that lead to uneven heating. In practice, this matters on the line. For PET blowing, the preform needs even surface heating to stretch consistently and hit the right wall thickness. These lamps deliver that heat quickly and predictably, so you end up with fewer rejects and less scrap. And because the design works across the Sidel range—SBO through Matrix—you can standardize your spares. One lamp type covers multiple machine generations, which simplifies inventory and cuts downtime when it’s time to swap one out. It’s a true drop-in replacement, as long as your socket is R7s and your cooling can handle it. When it’s spec’d right, you get the same thermal performance, with the same install time as a normal lamp change.